On Fri, 01 May 2015, Richard Fitzgerald wrote:
Signed-off-by: Richard Fitzgerald rf@opensource.wolfsonmicro.com
Documentation/devicetree/bindings/mfd/arizona.txt | 13 +++++++++---- 1 files changed, 9 insertions(+), 4 deletions(-)
Applied, thanks.
diff --git a/Documentation/devicetree/bindings/mfd/arizona.txt b/Documentation/devicetree/bindings/mfd/arizona.txt index 7665aa9..64fa3b2 100644 --- a/Documentation/devicetree/bindings/mfd/arizona.txt +++ b/Documentation/devicetree/bindings/mfd/arizona.txt @@ -10,6 +10,9 @@ Required properties: "wlf,wm5110" "wlf,wm8280" "wlf,wm8997"
"wlf,wm8998""wlf,wm1814"
- reg : I2C slave address when connected using I2C, chip select number when using SPI.
@@ -31,10 +34,10 @@ Required properties: as covered in Documentation/devicetree/bindings/regulator/regulator.txt
- DBVDD2-supply, DBVDD3-supply : Additional databus power supplies (wm5102,
- wm5110, wm8280)
wm5110, wm8280, wm8998, wm1814)
- SPKVDDL-supply, SPKVDDR-supply : Speaker driver power supplies (wm5102,
- wm5110, wm8280)
wm5110, wm8280, wm8998, wm1814)
- SPKVDD-supply : Speaker driver power supply (wm8997)
@@ -53,8 +56,10 @@ Optional properties: of input signals. Valid values are 0 (Differential), 1 (Single-ended) and 2 (Digital Microphone). If absent, INn_MODE registers set to 0 by default. If present, values must be specified less than or equal to the number of
- input singals. If values less than the number of input signals, elements
- that has not been specifed are set to 0 by default.
input signals. If values less than the number of input signals, elements
that have not been specified are set to 0 by default. Entries are:
<IN1, IN2, IN3, IN4> (wm5102, wm5110, wm8280, wm8997)
<IN1A, IN2A, IN1B, IN2B> (wm8998, wm1814)
- wlf,dmic-ref : DMIC reference voltage source for each input, can be
selected from either MICVDD or one of the MICBIAS's, defines