9 Apr
2018
9 Apr
'18
3:34 a.m.
Hi Nicolin,
On Sun, Apr 8, 2018 at 8:57 PM, Nicolin Chen nicoleotsuka@gmail.com wrote:
When the desired ratio is less than 256, the savesub (tolerance) in the calculation would become 0. This will then fail the loop- search immediately without reporting any errors.
But if the ratio is smaller enough, there is no need to calculate the tolerance because PM divisor alone is enough to get the ratio.
So a simple fix could be just to set PM directly instead of going into the loop-search.
Reported-by: Marek Vasut marex@denx.de Signed-off-by: Nicolin Chen nicoleotsuka@gmail.com Cc: Marek Vasut marex@denx.de
If this fixes Marek's usecase then I think we should also add:
Thanks