From: Fabio Estevam fabio.estevam@freescale.com
When trying to play a 8kHz file with codec in slave mode we get the following error on a mx28evk:
$ aplay -Dhw:0,0 stereo_8k.wav Playing WAVE 'stereo_8k.wav' : Signed 16 bit Little Endian, Rate 8000 Hz, Stereo [ 21.218647] sgtl5000 0-000a: PLL not supported in slave mode [ 21.224559] sgtl5000 0-000a: 128 ratio is not supported. SYS_MCLK needs to be 256, 384 or 512 * fs [ 21.233687] sgtl5000 0-000a: ASoC: can't set sgtl5000 hw params: -22 aplay: set_params:1123: Unable to install hw params:
This error happens because we are using 'sys_fs' instead of 'frame_rate' in the valid ratio check.
Use the real'frame_rate' so that the ratio is correctly calculated and the playback can run.
sgtl5000 codec manual states that in 'Synchronous SYS_MCLK input' mode that the following SYS_CLK frequencies are allowed: 256*fs, 384*fs, 512*fs.
, where fs is the sampling frequency, which can be in the range of: 8, 11.025, 16, 22.5, 32, 44.1, 48, 96 kHz.
Signed-off-by: Fabio Estevam fabio.estevam@freescale.com --- sound/soc/codecs/sgtl5000.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/sound/soc/codecs/sgtl5000.c b/sound/soc/codecs/sgtl5000.c index 8dea6b3..29cf7ce 100644 --- a/sound/soc/codecs/sgtl5000.c +++ b/sound/soc/codecs/sgtl5000.c @@ -618,7 +618,7 @@ static int sgtl5000_set_clock(struct snd_soc_codec *codec, int frame_rate) * factor of freq = 96 kHz can only be 256, since mclk is in the range * of 8 MHz - 27 MHz */ - switch (sgtl5000->sysclk / sys_fs) { + switch (sgtl5000->sysclk / frame_rate) { case 256: clk_ctl |= SGTL5000_MCLK_FREQ_256FS << SGTL5000_MCLK_FREQ_SHIFT; @@ -641,7 +641,7 @@ static int sgtl5000_set_clock(struct snd_soc_codec *codec, int frame_rate) "PLL not supported in slave mode\n"); dev_err(codec->dev, "%d ratio is not supported. " "SYS_MCLK needs to be 256, 384 or 512 * fs\n", - sgtl5000->sysclk / sys_fs); + sgtl5000->sysclk / frame_rate); return -EINVAL; } }