[alsa-devel] [PATCH V3 1/2] ASoC: fsl_asrc: replace the process_option table with function

S.j. Wang shengjiu.wang at nxp.com
Thu Apr 18 11:37:06 CEST 2019


Hi

> 
> On Thu, Apr 18, 2019 at 08:50:48AM +0000, S.j. Wang wrote:
> > > And this is according to IMX6DQRM:
> > >     Limited support for the case when output sampling rates is
> > >     between 8kHz and 30kHz. The limitation is the supported ratio
> > >     (Fsin/Fsout) range as between 1/24 to 8
> > >
> > > This should cover your 8.125 condition already, even if having an
> > > outrate range between [8KHz, 30KHz] check, since an outrate above
> > > 30KHz will not have an inrate bigger than 8.125 times of it, given
> > > the maximum input rate is 192KHz.
> > >
> > > So I think that we can just drop that 8.125 condition from your
> > > change and there's no need to error out any more.
> > >
> > No, if outrate=8kHz,  inrate > 88.2kHz, these cases are not supported.
> > This is not covered by
> >
> >         if ((outrate > 8000 && outrate < 30000) &&
> >             (outrate/inrate > 24 || inrate/outrate > 8)) {
> 
> Good catch. The range should be [8KHz, 30KHz] vs. (8KHz, 32KHz) in the
> code. Then I think the fix should be at both lines:
> 
> -         if ((outrate > 8000 && outrate < 30000) &&
> -             (outrate/inrate > 24 || inrate/outrate > 8)) {
> +         if ((outrate >= 8000 && outrate =< 30000) &&
> +             (outrate > 24 * inrate || inrate > 8 * outrate)) {
> 
> Overall, I think we should fix this instead of adding an extra one, since it is
> very likely saying the same thing.

Actually if outrate < 8kHz, there will be issue too.

Best regards
Wang shengjiu


More information about the Alsa-devel mailing list