[alsa-devel] [PATCH 3/5] media: i2c: Add TDA1997x HDMI receiver driver

[Rob Herring]

On Wed, Nov 15, 2017 at 10:31:14AM -0800, Tim Harvey wrote:
> On Wed, Nov 15, 2017 at 7:52 AM, Rob Herring <robh at kernel.org> wrote:
> > On Thu, Nov 09, 2017 at 10:45:34AM -0800, Tim Harvey wrote:
> >> Add support for the TDA1997x HDMI receivers.
> >>
> >> Cc: Hans Verkuil <hverkuil at xs4all.nl>
> >> Signed-off-by: Tim Harvey <tharvey at gateworks.com>
> >> ---
> >> v3:
> >>  - use V4L2_DV_BT_FRAME_WIDTH/HEIGHT macros
> >>  - fixed missing break
> >>  - use only hdmi_infoframe_log for infoframe logging
> >>  - simplify tda1997x_s_stream error handling
> >>  - add delayed work proc to handle hotplug enable/disable
> >>  - fix set_edid (disable HPD before writing, enable after)
> >>  - remove enabling edid by default
> >>  - initialize timings
> >>  - take quant range into account in colorspace conversion
> >>  - remove vendor/product tracking (we provide this in log_status via infoframes)
> >>  - add v4l_controls
> >>  - add more detail to log_status
> >>  - calculate vhref generator timings
> >>  - timing detection fixes (rounding errors, hswidth errors)
> >>  - rename configure_input/configure_conv functions
> >>
> >> v2:
> >>  - implement dv timings enum/cap
> >>  - remove deprecated g_mbus_config op
> >>  - fix dv_query_timings
> >>  - add EDID get/set handling
> >>  - remove max-pixel-rate support
> >>  - add audio codec DAI support
> >>  - change audio bindings
> >> ---
> >>  drivers/media/i2c/Kconfig            |    9 +
> >>  drivers/media/i2c/Makefile           |    1 +
> >>  drivers/media/i2c/tda1997x.c         | 3485 ++++++++++++++++++++++++++++++++++
> >>  include/dt-bindings/media/tda1997x.h |   78 +
> >
> > This belongs with the binding documentation patch.
> >
> 
> Rob,
> 
> Thanks - missed that. I will move it for v4.
> 
> Regarding your previous comment to the v2 series:
> > The rest of the binding looks fine, but I have some reservations about
> > this. I think this should be common probably. There's been a few
> > bindings for display recently that deal with the interface format. Maybe
> > some vendor property is needed here to map a standard interface format
> > back to pin configuration.
> 
> I take it this is not an 'Ack' for the bindings?
> 
> Which did you feel should be made common? I admit I was surprised
> there wasn't a common binding for audio bus format (i2s|spdif) but if
> you were referring to the video data that would probably be much more
> complicated.

The video data. Either you have to try to come up with some way to map 
color components to signals/pins (and even cycles) or you just enumerate 
the formats and keep adding to them when new ones appear. There's h/w 
that allows the former, but in the end you have to interoperate, so 
enumerating the formats is probably enough.

> I was hoping one of the media/driver maintainers would respond to your
> comment with thoughts as I'm not familiar with a very wide variety of
> receivers.

I am hoping, too.

Rob