[alsa-devel] [PATCH v1 4/6] ASoC: codecs: msm8916-wcd-analog: set default micbias voltage to 1.8

[Srinivas Kandagatla]

On 28/07/17 15:01, Mark Brown wrote:
> On Fri, Jul 28, 2017 at 02:54:59PM +0100, Srinivas Kandagatla wrote:
>> On 28/07/17 14:40, Mark Brown wrote:
>>> On Wed, Jul 26, 2017 at 02:35:10AM +0200, srinivas.kandagatla at linaro.org wrote:
>>>> From: Srinivas Kandagatla <srinivas.kandagatla at linaro.org>
> 
>>>> This patch sets the default internal micbias voltage to 1.8v. This
>>>> default value is required for mbhc buttons to work. Also adds dt
>>>> bindings to allow the board level file to specify the required default
>>>> micbias value.
> 
>>> What was the default previously?
> 
>> This was set to 2.7v previously for special headsets which have high
>> impedance.
> 
> So obviously this will break existing users.  That's not OK.

This would not break any exiting users, as this part is applicable for 
only headset detect usecase. I will try to address this in ("PATCH 5/6 
ASoC: codecs: msm8916-wcd-analog: add MBHC support") patch.

The default voltage for most common usecase should be set to 1.8v anyway.