[alsa-devel] [PATCH 2/3] ASoC: fsl: Add S/PDIF CPU DAI driver
B42378 at freescale.com
Wed Jul 31 16:12:18 CEST 2013
Thank you for the sage advices.
I'll revise the patch and send the v2.
From: Lars-Peter Clausen [lars at metafoo.de]
Sent: Wednesday, July 31, 2013 8:16 PM
To: Chen Guangyu-B42378
Cc: broonie at kernel.org; timur at tabi.org; alsa-devel at alsa-project.org; linuxppc-dev at lists.ozlabs.org; devicetree-discuss at lists.ozlabs.org; rob.herring at calxeda.com
Subject: Re: [alsa-devel] [PATCH 2/3] ASoC: fsl: Add S/PDIF CPU DAI driver
> new file mode 100644
> index 0000000..a655800
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/sound/fsl,spdif.txt
> @@ -0,0 +1,63 @@
> +Freescale Sony/Philips Digital Interface Format (S/PDIF) Controller
> +The Freescale S/PDIF audio block is a stereo transceiver that allows the
> +processor to receive and transmit digital audio via an coaxial cable or
> +a fibre cable.
> +Required properties:
> + - compatible : Compatible list, contains "fsl,spdif".
That's not what the driver says though.
> + - reg : Offset and length of the register set for the device.
> + - interrupts : <a b> where a is the interrupt number and b is a field that
> + represents an encoding of the sense and level information for the interrupt.
> + This should be encoded based on the information in section 2) depending on
> + the type of interrupt controller you have.
The exact layout of the cell depends on the parent interrupt controller, so
you probably shouldn't describe it here.
> + - clocks : The phandle for the clock ID number registered in clock tree.
> + - fsl,spdif-dma-events: The dma event ID numbers for Tx and Rx.
Use the generic DMA bindings.
> +Optional properties:
> + - rx-clk-source : The clock cource for Rx. Need to set this source according
> + to the SoC datasheet in SPDIF_SRPC section. If absent, the default source is
> + value 0x0 - if (DPLL Locked) SPDIF_RxClk else extal.
> + - tx-clk-source : The clock cources for Tx. There're three sources, each for
> + different supported sample rate, sequentially 32000Hz, 44100Hz and 48000Hz.
> + Need to set this source according to the SoC datasheet in SPDIF_STC section.
> + If absent, the default source is value 0x1 - CCM spdif0_clk_root input.
> + - tx-clk-div : The clock divider factor for Tx clock. There're three values,
> + each for different supported sample rate, sequentially 32000Hz 44100Hz 48000Hz.
> + Need to set this source according to the clock rate from the clock source.
> + If absent, the default divider factor is <37 23 37> by using spdif0_clk source.
Can't the driver figure out the divider values on its own based on the input
More information about the Alsa-devel