[alsa-devel] wm8974 and sam9g45 atmel

Mark Brown broonie at opensource.wolfsonmicro.com
Fri Jun 10 12:31:18 CEST 2011

On Thu, Jun 09, 2011 at 05:11:48PM +0200, Michele Da Rold wrote:
> Hello everybody, I'm starting a new development with a Atmel SAM9G45 and 
> a WM8974.

Please always CC maintainers on mails - traffic on the mailing list is
easily lost.

> I'm using kernel

This kernel is *very* old - I would strongly recommend updating to a
more current kernel if you're looking for support.

> Putting some dedug messagge the driver not call the function 
> "set_bias_level", and call the mute function with mute=0.
> Testing the MCLK signal I not see any clock on pin because I never call 
> clk_enable!!

Have you routed audio from the DAI to an output using the ALSA controls?
If you haven't connected an output path up then the kernel won't power
anything on.

More information about the Alsa-devel mailing list