[alsa-devel] [PATCH 3/8] MFD: twl4030-audio: Rename platform data

[Tony Lindgren]

* Peter Ujfalusi <peter.ujfalusi at ti.com> [110601 06:13]:
> On Wednesday 01 June 2011 16:00:34 Tony Lindgren wrote:
> > Yeah, most of it might be possible to describe with just a flags
> > like TWL_HAS_VIBRA etc.
> 
> Or TWL_BOARD_HAS_VIBRA, TWL_BOARD_HAS_CODEC...
> 
> For the audio part it is a bit complicated than that:
> different base frequencies, for twl6040 we have parameters for Vibra (twl4030 
> class only have the coexistence). The soc codec has a list of misc parameters 
> for board specific configurations as well (not all board using them).
> I was thinking to switch the MFD driver(s) to use flags to specify the needed 
> child, and change the child drivers to deal with the missing platform data 
> themselves.
> In that way, board files can pass the vibra/codec platform data to the new 
> i2c_twl file for example, and provide flags to enable functionality.

OK, sounds doable.
 
> > > I'll take a look, but I think it is not going to be part of v2 of this
> > > series.
> > 
> > We should not do renaming before the clean-up though, it gets
> > classified as "unnecesary churn".
> 
> The changes in board files are minimal. The biggest part is the code move, and 
> that will remain the same now or later...

But you could easily remove all the board specific struct twl4030_codec_data
and struct twl4030_codec_audio_data entries by adding a default audio
init option to omap_pmic_init for the common configuration.

How about something like:

void omap_pmic_init(int bus, u32 clkrate, const char *pmic_type, int pmic_irq,
                    struct twl4030_platform_data *pmic_data, u32 flags);

Where flags would be TWL_BOARD_HAS_DEFAULT_CODEC etc, and if the entry in
pmic_data is NULL, just use the default configuration. I think you already
have the clkrate there?

Regards,

Tony