[alsa-devel] [PATCH 1/4] ARM: OMAP1: ams-delta: set up regulator over modem reset GPIO pin
Janusz Krzysztofik
jkrzyszt at tis.icnet.pl
Sat Dec 24 00:12:21 CET 2011
The Amstrad Delta on-board latch2 bit named MODEM_NRESET, now available
as a GPIO pin AMS_DELTA_GPIO_PIN_NMODEM_RESET, is used to power up/down
(bring into/out of a reset state) two distinct on-board devices
simultaneously: the modem, and the voice codec. As a consequence, that
bit is, or can be, manipulated concurrently by two drivers, or their
platform provided hooks.
Instead of updating those drivers to use the gpiolib API as a new method
of controlling the MODEM_NRESET pin state, like it was done to other
drivers accessing latch2 pins, and still being vulnerable to potential
concurrency conflicts, or trying to solve that sharing issue with a
custom piece of code, set up a fixed regulator device on top of that
GPIO pin, with the intention of updating both drivers to manipulate that
regulator, not the GPIO pin directly.
Before the ASoC driver is updated to use that regulator, and the modem
platform data expanded with a power management callback for switching
its power, the ams_delta_latch_write() function, which still provides
the old API for accessing latch2 functionality from not updated drivers,
is modified to toggle the regulator instead of the MODEM_NRESET GPIO
pin. A helper function provided for balancing the regulator
enable/disable operations, together with the regulator consumer data
needed for maintaining its state, will be reused by the above mentioned
modem power management callback once implemented.
Depends on patch series "ARM: OMAP1: ams-delta: replace custom I/O with
GPIO".
Signed-off-by: Janusz Krzysztofik <jkrzyszt at tis.icnet.pl>
---
arch/arm/mach-omap1/Kconfig | 2 +
arch/arm/mach-omap1/board-ams-delta.c | 103 +++++++++++++++++++++++++++++++--
2 files changed, 99 insertions(+), 6 deletions(-)
diff --git a/arch/arm/mach-omap1/Kconfig b/arch/arm/mach-omap1/Kconfig
index 5b1edba..4b6a774 100644
--- a/arch/arm/mach-omap1/Kconfig
+++ b/arch/arm/mach-omap1/Kconfig
@@ -157,6 +157,8 @@ config MACH_AMS_DELTA
select FIQ
select GPIO_GENERIC_PLATFORM
select LEDS_GPIO_REGISTER
+ select REGULATOR
+ select REGULATOR_FIXED_VOLTAGE
help
Support for the Amstrad E3 (codename Delta) videophone. Say Y here
if you have such a device.
diff --git a/arch/arm/mach-omap1/board-ams-delta.c b/arch/arm/mach-omap1/board-ams-delta.c
index 673cf21..b5a1a3b 100644
--- a/arch/arm/mach-omap1/board-ams-delta.c
+++ b/arch/arm/mach-omap1/board-ams-delta.c
@@ -18,7 +18,11 @@
#include <linux/input.h>
#include <linux/interrupt.h>
#include <linux/leds.h>
+#include <linux/mutex.h>
#include <linux/platform_device.h>
+#include <linux/regulator/consumer.h>
+#include <linux/regulator/fixed.h>
+#include <linux/regulator/machine.h>
#include <linux/serial_8250.h>
#include <linux/export.h>
@@ -237,11 +241,6 @@ static struct gpio latch_gpios[] __initconst = {
.label = "scard_cmdvcc",
},
{
- .gpio = AMS_DELTA_GPIO_PIN_MODEM_NRESET,
- .flags = GPIOF_OUT_INIT_LOW,
- .label = "modem_nreset",
- },
- {
.gpio = AMS_DELTA_GPIO_PIN_MODEM_CODEC,
.flags = GPIOF_OUT_INIT_LOW,
.label = "modem_codec",
@@ -258,6 +257,73 @@ static struct gpio latch_gpios[] __initconst = {
},
};
+static struct regulator_consumer_supply modem_nreset_consumers[] __initconst = {
+ REGULATOR_SUPPLY("RESET#", "serial8250.1"),
+ REGULATOR_SUPPLY("POR", "cx20442-codec"),
+};
+
+static struct regulator_init_data modem_nreset_data __initconst = {
+ .constraints = {
+ .valid_ops_mask = REGULATOR_CHANGE_STATUS,
+ .boot_on = 1,
+ },
+ .num_consumer_supplies = ARRAY_SIZE(modem_nreset_consumers),
+ .consumer_supplies = modem_nreset_consumers,
+};
+
+static struct fixed_voltage_config modem_nreset_config __initconst = {
+ .supply_name = "modem_nreset",
+ .microvolts = 3300000,
+ .gpio = AMS_DELTA_GPIO_PIN_MODEM_NRESET,
+ .startup_delay = 25000,
+ .enable_high = 1,
+ .enabled_at_boot = 1,
+ .init_data = &modem_nreset_data,
+};
+
+static struct platform_device modem_nreset_device = {
+ .name = "reg-fixed-voltage",
+ .id = -1,
+ .dev = {
+ .platform_data = &modem_nreset_config,
+ },
+};
+
+struct regulator_consumer_data {
+ struct mutex lock;
+ struct regulator *regulator;
+ bool enabled;
+};
+
+static int regulator_toggle(struct regulator_consumer_data *consumer,
+ bool enable)
+{
+ int err = 0;
+
+ if (!consumer->regulator)
+ return -ENODEV;
+
+ mutex_lock(&consumer->lock);
+ if (IS_ERR(consumer->regulator)) {
+ err = PTR_ERR(consumer->regulator);
+ } else if (enable) {
+ if (!consumer->enabled) {
+ err = regulator_enable(consumer->regulator);
+ consumer->enabled = true;
+ }
+ } else {
+ if (consumer->enabled) {
+ err = regulator_disable(consumer->regulator);
+ consumer->enabled = false;
+ }
+ }
+ mutex_unlock(&consumer->lock);
+
+ return err;
+}
+
+static struct regulator_consumer_data modem_nreset;
+
void ams_delta_latch_write(int base, int ngpio, u16 mask, u16 value)
{
int bit = 0;
@@ -266,7 +332,10 @@ void ams_delta_latch_write(int base, int ngpio, u16 mask, u16 value)
for (; bit < ngpio; bit++, bitpos = bitpos << 1) {
if (!(mask & bitpos))
continue;
- gpio_set_value(base + bit, (value & bitpos) != 0);
+ if (base + bit == AMS_DELTA_GPIO_PIN_MODEM_NRESET)
+ regulator_toggle(&modem_nreset, (value & bitpos) != 0);
+ else
+ gpio_set_value(base + bit, (value & bitpos) != 0);
}
}
EXPORT_SYMBOL(ams_delta_latch_write);
@@ -496,6 +565,12 @@ static int __init late_init(void)
platform_add_devices(late_devices, ARRAY_SIZE(late_devices));
+ err = platform_device_register(&modem_nreset_device);
+ if (err) {
+ pr_err("Couldn't register the modem regulator device\n");
+ return err;
+ }
+
omap_cfg_reg(M14_1510_GPIO2);
ams_delta_modem_ports[0].irq =
gpio_to_irq(AMS_DELTA_GPIO_PIN_MODEM_IRQ);
@@ -514,8 +589,24 @@ static int __init late_init(void)
err = platform_device_register(&ams_delta_modem_device);
if (err)
goto gpio_free;
+
+ /*
+ * Once the modem device is registered, the modem_nreset
+ * regulator can be requested on behalf of that device.
+ * The regulator is used via ams_delta_latch_write()
+ * by the modem and ASoC drivers until updated.
+ */
+ mutex_init(&modem_nreset.lock);
+ modem_nreset.regulator = regulator_get(&ams_delta_modem_device.dev,
+ "RESET#");
+ if (IS_ERR(modem_nreset.regulator)) {
+ err = PTR_ERR(modem_nreset.regulator);
+ goto unregister;
+ }
return 0;
+unregister:
+ platform_device_unregister(&ams_delta_modem_device);
gpio_free:
gpio_free(AMS_DELTA_GPIO_PIN_MODEM_IRQ);
return err;
--
1.7.3.4
More information about the Alsa-devel
mailing list