[alsa-devel] HDMI LPCM (7.1) with AMD/FGLRX

[Andrée 'Glaucous']

I run
speaker-test -D hw:1,3 -c 8
Now it actually worked a bit. The speaker-test runs as it should, but
everytime it tries output to "none-two-channel" channel (LFE, Rear Left,
Rear Right.. etc),
it doesn't output anything. And I can see on the receiver that the (2
channel PCM stream, but should say 7.1 Multichannel) is lost every time
except for Front Left/Right channel.

On 9 August 2011 12:05, Takashi Iwai <tiwai at suse.de> wrote:

> At Tue, 9 Aug 2011 11:37:37 +0200,
> Andrée 'Glaucous' wrote:
> >
> > Current kernel message (using alsa-kernel, I'll clone and build your git
> > soon, got some internet problems at the moment):
> > [  147.334343] XXX HDMI pin_sense = 0x7fffffff
> > [  147.565059] XXX HDMI pin_sense = 0x7fffffff
> > [  153.248894] XXX HDMI pin_sense = 0xffffffff
> > [  153.250443] XXX HDMI pin_sense = 0xffffffff
> > [  189.475073] XXX HDMI pin_sense = 0x7fffffff
> > [  189.698017] XXX HDMI pin_sense = 0x7fffffff
> > [  196.664565] XXX HDMI pin_sense = 0xffffffff
> > [  196.666079] XXX HDMI pin_sense = 0xffffffff
> >
> > It recognizes when I take the cable in and out, or toggles display output
> > (0xffffffff when connected).
>
> OK, it's good to know.  It means that the pin-sense reports only the
> pin-detection but nothing else unlike other codecs.  So, it's
> basically bad to use generic HDMI parser for this codec.
>
> And, when you wrote "I still can't run speaker-test with more than 2
> channels", do you mean that you got an error?  How did you run?
> With the patch, the driver should take up to 8 channels.  If not,
> something was wrong -- either the patch wrongly applied or the patch
> wasn't enough.
>
>
> Takashi
>