[alsa-devel] Can't resume from suspend because firmware is not found ?!?

[Takashi Iwai]

At Sat, 12 Sep 2009 22:38:00 +0200,
Giuliano Pochini wrote:
> 
> I tested suspend/resume on a laptop because I failed to make it work on my
> G4 (grr!!). Suspend work, resume does not. From dmesg (below) it looks like
> the soundcard driver is asked to resume before the ATA driver, thus is
> cannot load the firmware. Am I overlooking something ?  Suggestions ?

You can't load the firmware file in resume phase because the system
isn't yet ready at this stage.  Either postpone it or keep the old
firmware and reuse it.


Takashi

> 
> ----
> Echoaudio Indigo IOx 0000:07:00.0: resume
> Echoaudio Indigo IOx 0000:07:00.0: PCI INT A -> GSI 18 (level, low) -> IRQ 18
> Echoaudio Indigo IOx 0000:07:00.0: enabling bus mastering
> ALSA echoaudio.c:2177: res res1
> Echoaudio Indigo IOx 0000:07:00.0: firmware: requesting ea/indigo_iox_dsp.fw
> PM: Adding info for No Bus:0000:07:00.0
> ata4.00: ACPI cmd ef/03:0c:00:00:00:a0 filtered out
> ata4.00: ACPI cmd ef/03:42:00:00:00:a0 filtered out
> ata4.00: configured for UDMA/33
> ata2: SATA link down (SStatus 0 SControl 300)
> ata3: SATA link down (SStatus 0 SControl 300)
> ata1: SATA link up 1.5 Gbps (SStatus 113 SControl 300)
> ata1.00: _GTF unexpected object type 0x1
> ata1.00: _GTF unexpected object type 0x1
> ata1.00: configured for UDMA/100
> tg3: eth0: Link is up at 10 Mbps, half duplex.
> tg3: eth0: Flow control is off for TX and off for RX.
> PM: Removing info for No Bus:0000:07:00.0
> ALSA echoaudio.c:47: get_firmware(): Firmware not available (-2)
> pm_op(): pci_pm_resume+0x0/0x79 returns -2
> PM: Device 0000:07:00.0 failed to resume: error -2
> ----
> 
> 
> -- 
> Giuliano.
> _______________________________________________
> Alsa-devel mailing list
> Alsa-devel at alsa-project.org
> http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
>